Technical Information

Cover

• Type 304 18 gauge satin polished stainless steel, all welded construction.

• Cover fixed to chassis by means of stainless steel Allen bolts

Power Pack

• Moulded, one piece ABS chassis

• Motor- external rotor brushless induction type operating at 2700 rpm

• Control - sophisticated (chip reads surroundings then operates when changes detected) passive infra-red automatic start/stop operation. Incorporates 60 second continuous running cut-out.

• Element - 1.83 Kw with thermal cut-out for isolation to prevent overheating

Insulation

• Earthed Class I

Weight

• 4.00 kg (4.5 kg packed)

Sound Level

• 65 dB(A) @ 1 metre

Rating

• 2.0 Kw @ 230v

Supply Voltage

• 220 -240 v |1|50 Hz

Operation

• Hands placed within 150mm of air outlet will effect machine start - dry hands being removed from airflow will cause machine to stop within 3 seconds

Installation

• Using template supplied, select recommended mounting height (normally 1.5m from FFL to top of unit) Provide power supply to rear entry position (recommended) or surface entry position (both bottom right) then using suitable fixings mount dryer to wall, connect and carry out normal test procedures

Specification

• Surface mounted warm air hand dryer shall be type 304 18 gauge stainless steel of all welded construction with anti-tamper allen bolts fixing cover to machine chassis.

• Power pack with infra-red 'no touch' operation will incorporate automatic cut-off and reset after 60 seconds continuous running. Manufacturers service and parts manual shall be provided to the building owner / operator upon project completion.