Technical Information

Cover

• Pressure die cast aluminium alloy with zinc alloy air diverter flap chrome plated to BS1224 Service Condition 'B'.

• Cover attached to machine chassis by means of 3 locating studs and 2 tamper resistant allen bolts

Power Pack

• Zinc plated steel chassis

• Motor - High Speed Brushed

• Suppressed 1/10 HP

• Control - sophisticated (chip reads surroundings then operates when changes detected) passive infra-red automatic start/stop operation. Incorporates 60 second continuous running cut-out.

• Element - 2.3 Kw with thermal cut-out for isolation to prevent overheating

Insulation

• Earthed Class I

Weight

• 6.0 kg (6.5 kg packed)

Sound Level

• 74 dB(A) @ 1 metre

Rating

• 2.4 Kw @ 230v

Supply Voltage

• 220 -240 v |1|50 Hz

Operation

• Hands placed within 150mm of air outlet will effect machine start - dry hands being removed from airflow will cause machine to stop within 3 seconds.For face drying- air diverter flap held in face position sends flow of warm air to face. On release flap re-sets to hands position and machine will switch off after 3 seconds.

Installation

• Using template supplied, select recommended mounting height (normally 1.5m from FFL to top of unit) Provide power supply to rear entry position (recommended) or surface entry position (both bottom right) then using suitable fixings mount dryer to wall, connect and carry out normal test procedures

Specification

• Surface mounted warm air hand/face dryer shall be pressure die cast aluminium alloy with zinc alloy air diverter flap all chrome plated to BS 1224 Service Condition 'B'. Power pack rated at 2.4 Kw with infra-red 'no touch' operation will incorporate automatic cut-off and reset after 60 seconds continuous running. Manufacturers service and parts manual shall be provided to the building owner / operator upon project completion.